Skoda Felicia

since 1994 release

Repair and operation of the car



Skoda Felicia
+ Cars of the Skoda Felicia brand
+ Maintenance instruction
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
- Brake system
   General information
   System design, description of separate knots and mechanisms
   Pumping of hydraulic system
   Replacement of hoses and tubes of a hydraulic path of the brake system
   Replacement of blocks of disk brake mechanisms of forward wheels
   Replacement of boots of drum brake mechanisms of back wheels
   Check of a state, removal and installation of disks of forward brake mechanisms
   Removal, check of a state and installation of reels of brake mechanisms of back wheels
   Removal, capital repairs and installation of supports of brake mechanisms of forward wheels
   Removal, capital repairs and installation of wheel cylinders of back brake mechanisms
   Removal, capital repairs and installation of the main brake cylinder (MBC)
   Removal and installation of a pedal of a foot brake
   Check of serviceability of functioning, removal and installation of the vacuum amplifier of brakes
   Removal, check of a state and installation of the control valve of the vacuum amplifier of brakes with a hose
   Adjustment of the parking brake
   Removal and installation of the lever of the parking brake
   Removal and installation of cables of the drive of the parking brake
   Check of serviceability of functioning, removal and installation of the valve regulator of pressure in hydraulic contours of brake mechanisms of back wheels
   Removal, installation and adjustment of the sensor switch of stoplights
   System of anti-blocking of brakes (ABS) - the general information
   Removal and installation of components of the ABS systems
   Removal and installation of the vacuum pump (diesel models)
   Check of a state and capital repairs of the vacuum pump (diesel models)
+ Suspension bracket and steering
+ Body and finishing of salon
+ Onboard electric equipment





Removal and installation of the vacuum pump (diesel models)

REMOVAL

 PERFORMANCE ORDER

1. The vacuum pump is fixed at the left on a forward wall of the block of cylinders.
2. Release a collar and disconnect a vacuum hose of the top part of the pump.
3. Turn out a fixing bolt and remove a clamp of fastening of the pump from the block of cylinders.
4. Take the pump from the block of cylinders, remove a sealing ring.

At assembly the sealing ring is subject to replacement without fail.

INSTALLATION

 PERFORMANCE ORDER

1. Install a new sealing ring on the pump, having slightly greased it for landing simplification.
2. Start the pump on the regular place. Track correctness of gearing of a groove of a driving gear wheel with a doggie of the leading shaft.
3. Establish a clamp and tighten a fixing bolt with the required effort.
4. Connect a vacuum hose to the pump and reliably fix it by a collar.




обучение полиграфологов