Skoda Felicia

since 1994 release

Repair and operation of the car



Skoda Felicia
+ Cars of the Skoda Felicia brand
+ Maintenance instruction
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
- Brake system
   General information
   System design, description of separate knots and mechanisms
   Pumping of hydraulic system
   Replacement of hoses and tubes of a hydraulic path of the brake system
   Replacement of blocks of disk brake mechanisms of forward wheels
   Replacement of boots of drum brake mechanisms of back wheels
   Check of a state, removal and installation of disks of forward brake mechanisms
   Removal, check of a state and installation of reels of brake mechanisms of back wheels
   Removal, capital repairs and installation of supports of brake mechanisms of forward wheels
   Removal, capital repairs and installation of wheel cylinders of back brake mechanisms
   Removal, capital repairs and installation of the main brake cylinder (MBC)
   Removal and installation of a pedal of a foot brake
   Check of serviceability of functioning, removal and installation of the vacuum amplifier of brakes
   Removal, check of a state and installation of the control valve of the vacuum amplifier of brakes with a hose
   Adjustment of the parking brake
   Removal and installation of the lever of the parking brake
   Removal and installation of cables of the drive of the parking brake
   Check of serviceability of functioning, removal and installation of the valve regulator of pressure in hydraulic contours of brake mechanisms of back wheels
   Removal, installation and adjustment of the sensor switch of stoplights
   System of anti-blocking of brakes (ABS) - the general information
   Removal and installation of components of the ABS systems
   Removal and installation of the vacuum pump (diesel models)
   Check of a state and capital repairs of the vacuum pump (diesel models)
+ Suspension bracket and steering
+ Body and finishing of salon
+ Onboard electric equipment





Adjustment of the parking brake

Performance of adjustment requires a steelyard.


 PERFORMANCE ORDER

1. Usually the tension of a driving cable of the parking brake is supported normal due to operation of automatic regulators of drum brake mechanisms of back wheels of the car. From time to time it is necessary to make additional individual adjustment for the purpose of compensation of a pulling of a cable. It is necessary to make adjustment only at removal of brake boots, drums, cables or the lever of the drive of the parking brake.
2. Having firmly squeezed out a foot brake, make sure of an isprvnost of a condition of the mechanism of self-regulation of back brake mechanisms.
3. Correctness of adjustment of the drive of the parking brake is checked by the number of clicks of a ratchet of a control lever at raising of the last with effort about 100 ÷ of 140 N (10 ÷ 14 kg). Completely release the lever, then connect a steelyard to its central part and pull for the handle of the last with the stipulated effort - the lever has to be cocked only on two clicks of the ratchet mechanism Important that the equalizer plate on the lever to which two driving cables are connected remained located at right angle to a lever axis that guarantees uniformity of applying of brake effort to both back wheels.
4. For carrying out adjustment remove back section of the central console, having provided thereby necessary access to the lever. If the console is not provided by a car design, release clamps and uncover the lever.
5. Release the lever, then on identical speed weaken lock-nuts of both driving cables on an equalizer plate. If the plate is located not at right angle to the lever, this situation also should be eliminated in the course of adjustment at the expense of an uneven otdavaniye of lock-nuts. Several times against the stop cock the lever, then repeat check of correctness of the executed adjustment.
6. Having achieved the correct tension of both driving cables, record adjusting nuts kontryashchy. Make sure that at completely released lever both back wheels rotate freely, then install into place the central console / a decorative cover of the lever.