Skoda Felicia
+ Cars of the Skoda Felicia brand
+ Maintenance instruction
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
- Brake system
General information
System design, description of separate knots and mechanisms
Pumping of hydraulic system
Replacement of hoses and tubes of a hydraulic path of the brake system
Replacement of blocks of disk brake mechanisms of forward wheels
Replacement of boots of drum brake mechanisms of back wheels
Check of a state, removal and installation of disks of forward brake mechanisms
Removal, check of a state and installation of reels of brake mechanisms of back wheels
Removal, capital repairs and installation of supports of brake mechanisms of forward wheels
Removal, capital repairs and installation of wheel cylinders of back brake mechanisms
Removal, capital repairs and installation of the main brake cylinder (MBC)
Removal and installation of a pedal of a foot brake
Check of serviceability of functioning, removal and installation of the vacuum amplifier of brakes
Removal, check of a state and installation of the control valve of the vacuum amplifier of brakes with a hose
Adjustment of the parking brake
Removal and installation of the lever of the parking brake
Removal and installation of cables of the drive of the parking brake
Check of serviceability of functioning, removal and installation of the valve regulator of pressure in hydraulic contours of brake mechanisms of back wheels
Removal, installation and adjustment of the sensor switch of stoplights
System of anti-blocking of brakes (ABS) - the general information
Removal and installation of components of the ABS systems
Removal and installation of the vacuum pump (diesel models)
Check of a state and capital repairs of the vacuum pump (diesel models)
+ Suspension bracket and steering
+ Body and finishing of salon
+ Onboard electric equipment
|
Removal, check of a state and installation of the control valve of the vacuum amplifier of brakes with a hose
REMOVAL
|
|
|
1. The control valve is built in a vacuum hose of the servo-driver of the brake amplifier.
|
|
2. Carefully release a vacuum hose from the servo-driver block, take the rubber plug through passage. |
|
|
3. Moving along a hose back, release it from all intermediate clamps, then release a collar and disconnect a hose from the inlet pipeline / the vacuum pump. Take assembly of a hose from a motive compartment. do not try to take out the valve from a hose. |
|
|
CHECK
|
|
|
1. Attentively examine the valve with a hose on existence of signs of mechanical damages. In case of need make replacement. Check of an isprvnost of functioning of the valve can be made by its produv in both directions. Air has to go through assembly only to one party - from the vacuum amplifier. Otherwise the valve is subject to replacement.
2. Check the rubber plug of the valve through passage for existence of damages and signs of aging of material. In case of need make replacement. |
|
INSTALLATION
|
|
|
1. Installation is made upside-down. Track correctness of laying of a hose and reliability of tightening of a fixing collar.
2. Densely put the plug through passage in the block of the servo-driver and pass throughout it the trailer union of a vacuum hose (try not to damage the plug).
3. In conclusion start the engine and check the corresponding components for existence of signs of leak of air. |
|
|
|
