Skoda Felicia

1. Open a cowl and enclose rags under both of its corners for the purpose of protection of a paint and varnish covering of body panels.
2. A marker lead round the loopy levels fixed on a cowl.

3. Ask the assistant to take a cover and turn out bolts of fastening of a cowl to levels of both loops. Throw off washers, then accurately remove a cowl from the car.

4. Attentively examine loops on existence of signs of wear and weakening of landing of rotary knots. In case of need make replacement (each loop fastens to a body three nuts).

1. By means of the assistant achieve placement of a cowl on the loops according to the tags put in the course of dismantle. Establish washers, screw and until only by hand, tighten fixing bolts. Correct the provision of loops according to tags, then tighten bolts finally.
2. Close a cowl and make sure of similarity of gaps between a cover and panels of both forward wings of the car. In case of need weaken loopy bolts and make necessary updating of the provision of a cover. Having achieved satisfactory result, strongly tighten loopy nuts / bolts and make sure of serviceability of operation of a latch of the lock.

3. Make sure that the cowl is located aflush with the surfaces of surrounding body panels. In case of need height of provision of a cowl can be corrected due to change of length of a finger of the drummer of the lock. As basic figure the firm manufacturer (Skoda) recommends to adhere to value in 38 ± 1 mm. For adjustment weaken a lock-nut and, respectively, screw or twist a finger at the required size. Having achieved required position, record in it a finger of the drummer and tighten a lock-nut with the required effort.