Skoda Felicia

1. Typical components of assembly of an external rear-view mirror are presented on an illustration.
2. Remove a rubber protective cover from the handle of adjustment of provision of a mirror, then give a nut on the regulator case.

3. Having hooked, remove a decorative cap, give the fixing screw and remove the triangular decorative panel from a door.

4. Turn out fixing screws and remove assembly of a mirror from a door. Remove the insulating laying established between a support of a mirror and a door and check its state. Defective laying is subject to replacement.

5. Installation is made upside-down.

1. Having hooked, take a decorative cap, then turn out the fixing screw and remove the triangular decorative panel from a door.
2. Turn out fixing screws and remove assembly of a mirror from a door, having in passing disunited the electrical wiring socket. Remove insulating laying. The damaged laying is subject to replacement.
3. Installation is made upside-down.

1. Incline mirror glass against the stop up, then pass a plastic or wooden wedge between the basis of glass and a casing of a frame and, having accurately hooked, separate glass from a driving electric motor / regulator.
2. Remove glass from a frame and disconnect an electrical wiring from a heating element.
3. At installation do not forget to connect an electrical wiring and track reliability of a zashchelkivaniye of glass on the electric motor/regulator (put effort only to the central part of glass for the purpose of minimization of casual damage of the last). Having made sure of reliability of fixing flew down, adjust mirrors, having given it into position.