Skoda Felicia

1. Open a door of a back and disconnect a negative wire from the battery.

2. On the models equipped with stoplights of the top level remove an alarm lamp (see the Head Onboard electric equipment), then accurately take the fixed secret nuts from a doorframe.

3. On all models remove rubber caps of the openings of access to screws of fastening of a spoiler located on the upper edge of a doorframe...

... turn out screws and remove assembly of a spoiler from a door, having in passing disconnected a washer hose.

4. Accurately release the panel of an internal upholstery from clamps and separate it from a door, then turn out the fixing screw and remove a gripping loop.

5. Disunite sockets of electric components of a door of a back and tie up a piece of a cord to a plait. Release an electrical wiring from intermediate clamps and take it from a doorframe.

Perhaps it is necessary to release contact plugs from the screen wiper drive electric motor socket for the purpose of a possibility of extraction of a plait from a door. In this case mark an electrical wiring for the purpose of a guarantee of correctness of connection it at assembly.

6. Lead round a marker loopy levels of a doorframe.
7. Ask the assistant to take a door, then accurately take fixing clamps and disconnect both persistent bars from the spherical hinges.

.8 Turn out bolts of fastening of loops to a door and remove the last from the car.

9. Check loops for existence of signs of wear and mechanical damages. In case of need separate the rear edge of the panel of a ceiling upholstery and you otboltit defective loops from a car body. replace loops and strongly tighten fixing bolts. Fix a ceiling upholstery.

Installation is made upside-down. Pay attention to the next moments:

a) Track correctness of installation of loopy levels on a door (according to the marking put in the course of dismantle);
b) Before installation of an insulating film and the panel of an internal upholstery of a door connect the battery and check serviceability of functioning of electric components of a door of a back;
c) Make sure of correctness of placement of a door in a body aperture. In case of need weaken loopy bolts and make the corresponding adjustment;
d) In conclusion check serviceability of functioning of the door lock. In case of need make adjustment of the drummer (see the Section Removal, installation and adjustment of components of the lock of a door of a back).

Installation is made as it should be, the return to a dismantle order.