Skoda Felicia

1. Disconnect a negative wire from the battery.
2. Remove the screen wiper lever (see the Section Removal and installation of levers of screen wipers).

3. Remove a protective cap from a spindle of a driving electric motor, then give a fixing nut and remove a washer and an external sealant.

4. Remove the panel of internal finishing from a back door, then give the fixing screw and remove a gripping loop. Accurately separate from a door an insulating film for the purpose of ensuring access to a screen wiper drive electric motor.

5. Turn out fixing bolts and remove the metal bracket established over the button of the door lock.

6. Disconnect an electrical wiring, then give the fixing screw and remove assembly of an electric motor from the seat. Remove an internal sealant and a washer(s) from a motor spindle. Remove the ring plug from a rubber pillow of a support. Check a condition of rubber components. Replace defective a sealant and a support pillow.

1. Put on a washer(s) and an internal sealant an electric motor spindle.
2. Start assembly of the motor on the regular place, then install the ring plug on a support pillow and screw the fixing screw.
3. Put on an external sealant and a washer a spindle, then screw and strongly tighten a shpindelny nut.
4. Strongly tighten the screw of fastening of the motor, then connect an electrical wiring.
5. Establish a metal bracket on a door, having strongly tightened its fixture.
6. Fix an insulating film and the panel of internal finishing on a door.
7. Install into place the screen wiper lever (see the Section Removal and installation of levers of screen wipers), then connect a negative wire to the battery.