Skoda Felicia

since 1994 release

Repair and operation of the car



Skoda Felicia
+ Cars of the Skoda Felicia brand
+ Maintenance instruction
+ Routine maintenance
- Repair of the engine
   + Repair without extraction from the car of the petrol engine of 1.3 l
   + Repair without extraction from the car of the petrol engine of 1.6 l
   - Repair without extraction from the car of the diesel engine
      Description of the main knots and mechanisms
      Reduction of the piston of the first cylinder in the provision of the top dead point (TDP) of the end of a step of compression
      Check of tightness of combustion chambers
      Removal and installation of a belt of the GRM drive and its covers
      Removal and installation of a natyazhitel and cogwheels of a belt of the GRM drive
      Removal, installation and adjustment of a tension of a belt of the drive of auxiliary units
      Removal and installation of a cover of a head of cylinders
      Replacement of an epiploon of the camshaft
      Replacement of an epiploon of an intermediate shaft
      Replacement of epiploons of a bent shaft
      Removal and installation of a head of cylinders assembled with the inlet pipeline and a final collector
      Check of serviceability of functioning of hydraulic pushers
      Flywheel - removal, check and installation
      Support of the power unit - check and replacement
      The pallet - removal, check and installation
      Removal and installation of the oil pump and assembly of a maslozabornik
   + Dismantle of the power unit and capital repairs of the engine
+ Cooling systems, heating
+ Power supply system
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and finishing of salon
+ Onboard electric equipment





Removal and installation of a cover of a head of cylinders

REMOVAL

 PERFORMANCE ORDER

1. Disconnect a tube of system of ventilation of a case from a cover of a head of cylinders. If the sealing plug through passage is damaged, pick up replaceable suitable on a standard size.
2. Having hooked, take caps, give three fixing nuts, remove washers and a sealant. Try to remember the adjusting provision of the removed components. The damaged washers are subject to replacement.
3. Having in case of need tapped on perimeter the hammer with soft brisk, uncover a head.
4. Remove laying, attentively study its state, in case of identification of signs of aging of material or mechanical damages pick up replaceable.
5. Carefully smooth out the interfaced surfaces of a cover and a head of cylinders, having completely removed from them traces of oil and material of old laying.

INSTALLATION

 PERFORMANCE ORDER

Installation is made upside-down. Pay attention to the next moments:

a) Track correctness of placement of laying on a head - all provided openings have to are combined with available in the interfaced surface;
b) Make sure of presence on the regular places on three hairpins of a cover of sealing cones;
c) Try not to displace laying in the course of lowering of a cover on a head;
d) Establish in a former order of a washer and a sealant, then screw fixing nuts and tighten them with the required effort. Establish caps;
e) Restore initial connection of a ventilating tube, having in case of need replaced the sealing plug through passage.