Skoda Felicia

since 1994 release

Repair and operation of the car


Skoda Felicia
+ Cars of the Skoda Felicia brand
+ Maintenance instruction
+ Routine maintenance
- Repair of the engine
   + Repair without extraction from the car of the petrol engine of 1.3 l
   + Repair without extraction from the car of the petrol engine of 1.6 l
   - Repair without extraction from the car of the diesel engine
      Description of the main knots and mechanisms
      Reduction of the piston of the first cylinder in the provision of the top dead point (TDP) of the end of a step of compression
      Check of tightness of combustion chambers
      Removal and installation of a belt of the GRM drive and its covers
      Removal and installation of a natyazhitel and cogwheels of a belt of the GRM drive
      Removal, installation and adjustment of a tension of a belt of the drive of auxiliary units
      Removal and installation of a cover of a head of cylinders
      Replacement of an epiploon of the camshaft
      Replacement of an epiploon of an intermediate shaft
      Replacement of epiploons of a bent shaft
      Removal and installation of a head of cylinders assembled with the inlet pipeline and a final collector
      Check of serviceability of functioning of hydraulic pushers
      Flywheel - removal, check and installation
      Support of the power unit - check and replacement
      The pallet - removal, check and installation
      Removal and installation of the oil pump and assembly of a maslozabornik
   + Dismantle of the power unit and capital repairs of the engine
+ Cooling systems, heating
+ Power supply system
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and finishing of salon
+ Onboard electric equipment


Removal, installation and adjustment of a tension of a belt of the drive of auxiliary units

General information

The auxiliary belt is used for the drive from a pulley of a bent shaft of such devices as the generator, steering and water pumps.

The multicostal auxiliary belt is equipped with the device of automatic adjustment

REMOVAL

 PERFORMANCE ORDER

1. Park the car on the flat horizontal platform, cock the parking brake and prop up wedges back wheels. Release nuts of fastening of the right forward wheel.
2. A car front also establish to Poddomkratta it on props. Remove the right forward wheel.
3. Turn out fixing screws and uncover a belt.

4. Check a belt for existence of factory direction signs of rotation. In case of need put the corresponding marking independently.
5. Rozhkov a key on 15 mm develop a roller of a natyazhitel counterclockwise, overcoming effort of a spring.

6. Take off a belt from a generator pulley, then from other pulleys.

Installation and adjustment of a tension

 PERFORMANCE ORDER

At installation of a belt be guided on marking of the direction of its rotation.

1. Throw with a belt a pulley of a bent shaft. Track that belt profile edges correctly were placed in pulley streams.
2. Overcoming spring resistance, Rozhkov a key develop a roller of a natyazhitel counterclockwise.
3. Get a belt the flat party under a roller of a natyazhitel, then put on it the remained pulleys. Track hit of edges in streams.
4. Having released a roller, allow it to pull a belt.
5. Establish into place a cover and strongly tighten screws of its fastening.
6. Establish a wheel, lower the car on the earth, then tighten bolts of fastening of a wheel with the required effort.