Skoda Felicia

since 1994 release

Repair and operation of the car



Skoda Felicia
+ Cars of the Skoda Felicia brand
+ Maintenance instruction
+ Routine maintenance
- Repair of the engine
   - Repair without extraction from the car of the petrol engine of 1.3 l
      Description of the main knots and mechanisms
      Check of a condition of conrod and piston group on hearing and measurement of compression pressure in cylinders
      Reduction of the piston of the first cylinder in the provision of the top dead point (TDP)
      Removal and installation of a cover of a casing of the camshaft
      Removal, check of a state and installation of assembly of an axis of yokes
      Removal and installation of a head of cylinders assembled with the inlet pipeline and a final collector
      Removal, check of a state and installation of a forward cover, chain and asterisks of the GRM drive
      Removal, check of a state and installation of components of the oil pump
      Removal and installation of the pallet of a case of the engine
      Replacement of epiploons of a bent shaft
      Removal, check of a state and installation of a flywheel
      Check of a state and replacement of rubber pillows of support of a suspension bracket of the power unit
      Removal, installation and adjustment of effort of a tension of a belt of the drive of auxiliary units
   + Repair without extraction from the car of the petrol engine of 1.6 l
   + Repair without extraction from the car of the diesel engine
   + Dismantle of the power unit and capital repairs of the engine
+ Cooling systems, heating
+ Power supply system
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and finishing of salon
+ Onboard electric equipment



Removal and installation of the pallet of a case of the engine

REMOVAL

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Prop up wedges back wheels of the car, then a front of the car and establish to a poddomkratta it on props.
3. Merge motive oil, then screw into place a drain stopper and tighten it with the required effort. If time of replacement of oil according to the Schedule of routine maintenance comes (see the Head Routine maintenance), replace an oil filter.

4. Under the car turn out a bolt of fastening of a branch pipe of a cooling path to an arm at the right end face of the pallet of a case.

5. In the sequence, return specified illustrations, in stages give bolts of fastening of the pallet. Try to remember the adjusting provision of an arm of a tube of a cooling path for which fixing the right bolt of fastening of the pallet is used.

6. Tap the pallet a palm for the purpose of office it from the engine block, then lower and take from under the car.
7. Taking an opportunity, wash out the mesh filter of a maslozabornik. At strong pollution of a grid replace the filter (in case of need see the Section Removal, check of a state and installation of components of the oil pump).

INSTALLATION

 PERFORMANCE ORDER

1. Carefully smooth out the interfaced surfaces of the pallet and the block of cylinders, having completely removed from them oil traces, then dry wipe the pallet and the internal surfaces of the engine with pure rags.

2. Lay new laying on the interfaced surface of the pallet,

... press the pallet to the engine and by hand tighten fixing bolts.

3. Working in the order specified illustrations tighten pallet bolts with the required effort.

 

4. Screw and strongly tighten a bolt of fastening of a tube of a cooling path. Lower the car on the earth and connect a negative wire to the battery.
5. Fill in in the engine engine oil (see the Head Routine maintenance).