Skoda Felicia

Remove the panel of an internal upholstery of a door (see the Section Removal and installation of panels of an internal upholstery of doors).

1. Turn out fixing screws, remove washers, disconnect the internal handle from an executive rod and remove it from a door.
2. Accurately separate from a door the upper edge of an insulating film for the purpose of ensuring access to the window regulator regulator mechanism.
3. Lower glass so that access to bolts of its fastening to the regulator through a special window in a doorframe opened.

4. Accurately release the lower sealing film from a window opening and shoot it from a door.

5. Turn out four bolts of fastening of a windowpane to the window regulator regulator, remove washers, then lift glass up and take it from a door.

1. Perform the procedures described in paragraphs with 2 on 4.

2. Components of the mechanism of a window regulator are presented on an illustration. Turn out four bolts of fastening of glass to the window regulator regulator, remove washers, then lift glass in the top situation and glue it an adhesive tape to a doorframe. 1 — the Cover 2 — glass movement Limiters 3 — the window regulator drive Handle

3. On the models equipped with the electric drive of window regulators release a clamp and disunite the socket of an electrical wiring of the driving motor.
4. On all models give nuts of fastening of assembly of the regulator to a doorframe, remove washers, then accurately take assembly through the provided opening.

1. Turn out screws of fastening of the internal handle of the lock, remove washers, then disconnect the handle from an executive rod of the lock and remove it from a door.
2. Accurately separate from a doorframe the upper edge of an insulating film for the purpose of ensuring access to the window regulator regulator mechanism.

3. Completely lower glass, then release the lower sealing tape of a window opening from a doorframe.

4. Give fastening screws to a door of the directing trench to a door, then take from a doorframe assembly of a trench with the fixed glass of a back window leaf.

5. A marker lead round on perimeter of a washer of bolts of fastening of glass to the window regulator regulator.
6. Turn out glass fastening bolts, remove washers, then lift glass up and take it from a doorframe.

2. A marker lead round washers of bolts of fastening of a windowpane to the window regulator regulator.
3. Turn out bolts of fastening of glass to the regulator, remove washers, then lift glass in the top situation and glue it an adhesive tape to a doorframe.
4. Give nuts of fastening of assembly of the regulator to a doorframe, remove washers, then accurately take assembly through the provided opening.

Installation is made upside-down. Pay attention to the next moments:

a) Track correctness of installation of sealing tapes of window openings;
b) At installation of glass track correctness of landing it in the directing trenches. Strongly tighten bolts of fastening of glass to the regulator;
c) Before establishing into place an insulating film and the panel of an internal upholstery of a door (see the Section Removal and installation of panels of an internal upholstery of doors), check serviceability of functioning of a window regulator. In case of need insignificant adjustment can be made by weakening of fixing bolts and updating of the provision of glass on the regulator.