Skoda Felicia

since 1994 release

Repair and operation of the car



Skoda Felicia
+ Cars of the Skoda Felicia brand
+ Maintenance instruction
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system
- Engine electric equipment
   + Systems of a charge and start
   + System of ignition of petrol engines
   + System of preheat of diesel engines
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and finishing of salon
+ Onboard electric equipment



Engine electric equipment

Specifications

Systems of start and charge

General parameters
System type 12-voltny, with grounding on a negative pole
Starter
Type Magneton
The developed power, kW (at a voltage of 12 V)
Petrol engines of 1.3 l of release till June, 1995. 0.8
Petrol engines of 1.3 l of release since June, 1995 and engines of 1.6 l 1.0
Diesel engines 1.8
Generator
Type
Models of 1.3 l of a complete set LX Magneton 55
Models of 1.3 l with To/in Magneton 90 (with a pulley under a multicostal belt)
Models of 1.6 l Magneton 90 or Bosch 70 (depending on a complete set)
Diesel models Any of listed above depending on a complete set
Minimum admissible residual length of brushes, mm 5 (+1,-0)
The given current, And 55 ё 90 (depending on model of the car and its complete set)
Tension regulator Tesla WIND914 or DLR-2P
Efforts of tightening of threaded connections Nanometer
Models of 1.3 l
Bolt of fastening of a basic arm of an adjusting level of the generator to a head of cylinders * 26
Nuts of an arm of the lower support 24
Models of 1.6 l
Bolts of fastening of the generator 23
Bolts of fastening of basic arms to the engine 45
Diesel models
Bolts of fastening of basic arms of the generator to the engine 25
All models
Bolts clamping forms of fastening of the battery 50
Nuts of fastening of a wire of a starter 14
Fixture of support of a starter
Nuts 50
Bolts/hairpin 60
Nuts of an expansion bar of support of racks of a forward suspension bracket (replacements are subject) 20
* It is used with the fixing sealant.
System of ignition of petrol engines
General parameters
System type *
Engines of 1.3 l of a series 135B and 136B Bosch Mono-Motronic
Engines of 1.3 l of a series 135M and 136M Simos 2P (without ignition distributor)
Engines of 1.6 l of the AEE series Magneti-Marelli 1AV
Ignition advancing corner, ° before VMT
Carburetor models
Basic data for control of installation of a corner of an advancing of ignition in dependence
15 kPa (112.78 mm of mercury.) 0 ° ÷ 1 ° 30'
20 kPa (150.38 mm of mercury.) 1 ° 30' ÷ 4 ° 30'
23 kPa (172.93 mm of mercury.) 3 ° 30' ÷ 6 ° 30'
25 kPa (187.96 mm of mercury.) 4 ° 15' ÷ 7 ° 15'
30 kPa (225.56 mm of mercury.) 6 ° 30' ÷ 9 ° 30'
35 kPa (263.15 mm of mercury.) 8 ° 30' ÷ 11 ° 30'
Control of functioning of the centrifugal proofreader of the moment of ignition
With a frequency of rotation of the engine 800 ё 1200 rpm 0 ° ÷ 4 °
With a frequency of rotation of the engine of 1500 rpm 2 ° 30' ÷ 10 ° 30'
With a frequency of rotation of the engine of 2000 rpm 7 ° ÷ 15
With a frequency of rotation of the engine of 3000 rpm 15 ÷ 25
With a frequency of rotation of the engine of 4200 rpm 25 ° 30' ÷ 33 ° 30'
SPFI and MPFI models It is controlled by a control system of the engine
* Numbers of a series of engines see in Specifications to the Head Remont of the engine.
Ignition coil
Carburetor models
Type PAL Kromeriz
Bosch Mono-Motronic
Resistance of primary winding, Ohm 0.5 ÷ 0.7
Resistance of a secondary winding, Ohm 3000 ÷ 4000
Magneti-Marelli 1AV
Resistance of primary winding, Ohm 0.5 ÷ 1.5
Resistance of a secondary winding, Ohm 3000 ÷ 4000
Ignition distributor Bosch/0237521061
Own resistance of the coil of the sensor of impulses, kOhm 3400 ÷ 400
Resistance of the resistor of suppression of hindrances, kOhm 4 ÷ 6
The size of an air gap between a rotor and contacts of a rotary plate, mm 0.2 ÷ 0.5
Wire VV
Specific ohmic resistance, Ohm/m 30 000
Spark plugs
Type
PAL Super 67Y, 617Y, 617YS, D17Y, D17YS
Bosch H8D, H8DC, H7DC, 7DC
Champion BN9Y, S9YC
NGK BP6EFS
Size of an interelectrode gap, mm 0.6 ÷ 0.7 mm
Efforts of tightening of threaded connections Nanometer
Coupling bolts of the distributor of ignition:
Bosch Mono-Motronic 10
Magneti-Marelli 1AV 25
Bolt of fastening of the sensor of Hall 10
Bolts/nut of fastening of the coil of ignition 10
Bolt of fastening of the sensor of a detonation 20
System of preheat of diesel engines
Glow plugs
Electric resistance, Ohm 1.5 (approximately)
Force of the passed current, And 8 (on a candle)
Efforts of tightening of threaded connections Nanometer
Glow plugs
Candles with washers 20 ÷ 30
Candles with conical landing 10 ÷ 14