Skoda Felicia

since 1994 release

Repair and operation of the car


Skoda Felicia
+ Cars of the Skoda Felicia brand
+ Maintenance instruction
+ Routine maintenance
+ Repair of the engine
- Cooling systems, heating
   General information and precautionary measures
   Detachment and replacement of hoses of the cooling system
   Removal, check of a state and installation of a radiator
   Removal, check of serviceability of functioning and installation of the thermostat
   Check of serviceability of functioning, removal, installation, dismantling and assembly of the fan of the cooling system
   Check of serviceability of functioning, removal and installation of electric switches and sensors of the cooling system
   Removal, installation, dismantling and assembly of the water pump
   System of heating/ventilation of salon - the general information
   Removal and installation of components of system of heating/ventilation of salon
   The air conditioning system - the general information and precautionary measures
   Removal and installation of components of the air conditioning system
+ Power supply system
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and finishing of salon
+ Onboard electric equipment

сигареты импортные пал мел

Cooling systems, heating

Specifications

General parameters
The maximum pressure in system, bar 1.2 ÷ 1.5
Thermostat
Opening temperature (approximately), °C
Beginning of opening 85 ÷ 89
Full opening 103
Minimum extent of opening of the valve, mm 7
Multicostal driving belt
Manufacturers Contitech and Optibelt
Number of edges/length, mm
Engine of 1.3 l 4/950
The engine 1.3 with To/in 6/1680 (drive of the generator, water pump and K/V compressor)
Engine of 1.6 l 6/751
The engine of 1.6 l with To/in 6/1080
The engine of 1.6 l with PAS 6/1070
The engine of 1.6 l with K/B and PAS 6/1125
Diesel engine of 1.9 l 5/1219
The epiploons used in the water pump
Size, mm
"Simrax" * Akh10k-12E04 **
And (see an illustration the Water pump (longitudinal section)) 73.2 ÷ 73.8
In 19.3 ÷ 19.4
With 9.3 ÷ 9.9
"Crane" 106 C ***
And (see an illustration the Water pump (longitudinal section)) 73.2 ÷ 73/8
In 19.3 ÷ 19.4
With 10:32 ÷ 19.48
* Externally differs in existence of the additional condensing varnish put on outer diameter.
** The press fitting is made by means of MP1-503/1 adaptation (see the Section Removal and installation of components of system of heating/ventilation of salon)
*** The press fitting is made by means of MP1-503/2 adaptation (see the Section Removal and installation of components of system of heating/ventilation of salon)
Efforts of tightening of threaded connections Nanometer
Cooling system fan sensor switch 40
Water pump
Petrol engine of 1.3 l
Casing nuts 20
Petrol engines of 1.6 l
Bolts of fastening of the pump 20
Diesel engine
Bolts of fastening of the pump to a casing 10
Pump pulley bolts 25
Bolts of fastening of a casing of the pump to the block 25
Lower bolt of fastening of TNVD 25
Bolts of fastening of a cover of the thermostat 10