Skoda Felicia

since 1994 release

Repair and operation of the car



Skoda Felicia
+ Cars of the Skoda Felicia brand
+ Maintenance instruction
+ Routine maintenance
- Repair of the engine
   + Repair without extraction from the car of the petrol engine of 1.3 l
   + Repair without extraction from the car of the petrol engine of 1.6 l
   - Repair without extraction from the car of the diesel engine
      Description of the main knots and mechanisms
      Reduction of the piston of the first cylinder in the provision of the top dead point (TDP) of the end of a step of compression
      Check of tightness of combustion chambers
      Removal and installation of a belt of the GRM drive and its covers
      Removal and installation of a natyazhitel and cogwheels of a belt of the GRM drive
      Removal, installation and adjustment of a tension of a belt of the drive of auxiliary units
      Removal and installation of a cover of a head of cylinders
      Replacement of an epiploon of the camshaft
      Replacement of an epiploon of an intermediate shaft
      Replacement of epiploons of a bent shaft
      Removal and installation of a head of cylinders assembled with the inlet pipeline and a final collector
      Check of serviceability of functioning of hydraulic pushers
      Flywheel - removal, check and installation
      Support of the power unit - check and replacement
      The pallet - removal, check and installation
      Removal and installation of the oil pump and assembly of a maslozabornik
   + Dismantle of the power unit and capital repairs of the engine
+ Cooling systems, heating
+ Power supply system
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and finishing of salon
+ Onboard electric equipment



The pallet - removal, check and installation

REMOVAL

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Merge motive oil.
3. Park the car on a plain horizontal surface, whenever possible with a hard coating. Cock the parking brake and prop up wedges back wheels.
4. A car front also establish to Poddomkratta it on props.
5. Moving on pallet perimeter, in stages weaken and turn out fixing bolts (the otdavaniye of two bolts located from transmission requires the cardan drive to a face key).
6. Having tapped a palm, separate the pallet from the block of cylinders and take it from under the car. Remove and will throw out old laying. If the maslootrazhatel is provided, his removal becomes possible only after dismantle of the oil pump.
7. Taking an opportunity, check a state and passability of a tube and the mesh filter of a maslozabornik of the pump. In case of need remove the pump (see the Section Removal and installation of the oil pump and assembly of a maslozabornik) and clean (or replace) the mesh filter.

INSTALLATION

 PERFORMANCE ORDER

1. Carefully smooth out the interfaced surfaces, having completely removed from them the remains of material of old laying or sealant. Then wipe surfaces with the rags moistened in acetone.
2. Having made sure of absoluteness of purity and dryness of the interfaced surfaces of the pallet and block of cylinders, grease them with a sealant layer.
3. Lay new laying on the interfaced surface, then press the pallet to the block and screw fixing bolts. In stages evenly tighten pallet fixture with the required effort.
4. Fill in in the engine necessary amount of engine oil of the required grade (see the Head Routine maintenance).
5. Connect a negative wire to the battery.