Skoda Felicia

1. A car front also establish to Poddomkratta it on props.
2. Check rubber pillows of support for existence of cracks, signs of hardening, peelings of rubber from a metal basis and other mechanical damages. In case of detection of this sort of defects the faulty support is subject to replacement.
3. By means of a dynamometer key check correctness of effort of tightening of threaded connections of support.
4. Using the big screw-driver or mount as the lever, estimate degree of wear of support (whenever possible use the help of the assistant, having asked it to shake the power unit here and there). In case of identification of an excessive side play the worn-out support should be replaced, previously having checked reliability of tightening of its fixture.

1. Disconnect a negative wire from the battery.
2. You will hang out the engine by means of the winch, or having propped up it a jack (between a head of a jack and the pallet of a case for distribution of loading it is necessary to lay wooden whetstone).

3. Turn out the top coupling bolt to an iotsoyedinita a support...

... trying to remember the adjusting provision of the removed components, take a rubber pillow from assembly.

4. Now the remained bolts can be turned out, and the support is removed from a wheel arch mudguard.
5. In case of need the lower part of a support can be separated from the engine block after preliminary removal of covers of a belt of the GRM drive (see the Section Removal and installation of a belt of the GRM drive and its covers).
6. Installation is made upside-down. Do not forget to replace fixing bolts and to slightly oil them before installation by lubricating. Tighten all fixture with the required effort.