Skoda Felicia

since 1994 release

Repair and operation of the car


Skoda Felicia
+ Cars of the Skoda Felicia brand
+ Maintenance instruction
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system
- Engine electric equipment
   + Systems of a charge and start
   - System of ignition of petrol engines
      General information
      Diagnostics of malfunctions of system of ignition and check of a condition of its components
      Removal and installation of the coil of ignition
      Removal and installation of the distributor of ignition
      Check and correction of a corner of an advancing of ignition
      Removal and installation of information sensors of system of ignition
   + System of preheat of diesel engines
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and finishing of salon
+ Onboard electric equipment


Removal and installation of the coil of ignition

REMOVAL

 PERFORMANCE ORDER

Make sure that ignition is switched off, then disconnect a negative wire from the battery.


Bosch Mono-Motronic system

 PERFORMANCE ORDER

1. The coil of ignition is installed in a forward part of a mudguard of an arch of the right wheel, in the neighbourhood with the distributor.

2. Disunite NV the coil socket, and also disconnect from it VV a wire

3. Turn out fixing bolts and remove the coil.


Simos 2P system

 PERFORMANCE ORDER

1. The bobbin module of system is installed on spark plugs in a forward part of the engine.

2. Disunite the electric socket at a module end face.

3. Turn out two fixing bolts in the lower part of the module.

4. Accurately, trying to incline not too strongly, remove the module from spark plugs.


Magneti-Marelli 1AV system

 PERFORMANCE ORDER

1. The coil of ignition is installed on a mudguard of an arch of the left wheel, near ECU.
2. Disunite NV the electric socket and disconnect a wire from the VV coil.
3. Give fixture (nuts/bolts) and remove the coil from a basic plate.

INSTALLATION

 PERFORMANCE ORDER

Installation is made upside-down. Track reliability of electric connections.