Skoda Felicia

since 1994 release

Repair and operation of the car



Skoda Felicia
- Cars of the Skoda Felicia brand
   Identification numbers of the car
   Acquisition of spare parts
   Technology of service, tool and equipment of a workplace
   Operations procedure in extreme situations
   Start of the engine from the auxiliary power supply
   Change of wheels
   Poddomkrachivaniye and towage
   Identification of leaks
   Checks of readiness of the car for operation
   Automobile chemicals, oils and lubricants
   Diagostika of malfunctions of knots and systems of the car
   Features of traffic regulations of the countries of Europe
+ Maintenance instruction
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and finishing of salon
+ Onboard electric equipment



Start of the engine from the auxiliary power supply

 


1. Connect the end of a red wire from a special set to the positive plug of the sat-down battery.
2. Connect the second end of a red wire to the positive plug of the auxiliary battery.
3. Connect one end of a black wire from a set to the negative plug of the auxiliary battery.
4. Connect the second end of a black wire to reliably grounded point on the block of the started engine (a bolt or an arm), whenever possible far away from the battery.
5. Make sure that connecting wires do not adjoin to moving components in motive compartments of both cars (a krylchatka of the fan, driving belts, etc.).
6. Perform the standard procedure of start of the engine. Leave the engine working at single turns. Include headlights, a heater of back glass and the fan of a heater, then disconnect wires, working as it should be, the return to an order of their connection. At the end of the procedure switch off excess consumers of the electric power.

Inclusion of auxiliary consumers of the electric power is made for the purpose of prevention of power surges at the time of an electrical wiring detachment.


Use of the auxiliary power supply will help to make start of the engine in an extreme situation, however then it is necessary to find out and remove the cause of replanting of the battery, the most typical of which are:

1. Carrying out numerous unsuccessful attempts of start of the engine, or leaving for a long time included lighting fixtures at the killed engine.
2. Violation of serviceability of functioning of system of a charge (the driving belt of the generator weakened or is torn off, the connecting electrical wiring is damaged, or the generator is faulty actually).
3. Malfunction of actually rechargeable battery (electrolyte level fell, or there was accumulator service life).

When performing start of the engine from the external power supply it is necessary to pay attention to observance of some special precautionary measures:

 -  Before connecting the auxiliary battery make sure that ignition is switched off.
 -  Track that all consumers of the electric power (lighting and heating fixtures, screen wipers, etc.) were also switched off
 -  Attentively study the warning information on the label of the battery.
 -  Make sure that the auxiliary battery on the output tension corresponds established on your car.
 -  If as the auxiliary power supply the battery installed on other vehicle is used, track that cars did not adjoin with each other AT ALL.
 -  Make sure that transmission is included on neutral transfer.