Skoda Felicia

since 1994 release

Repair and operation of the car



Skoda Felicia
+ Cars of the Skoda Felicia brand
+ Maintenance instruction
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system
+ Engine electric equipment
+ Coupling
- Transmission
   General information
   Description of knots and mechanisms
   Removal and installation of drafts of the drive of gear shifting
   Replacement of epiploons
   Check of serviceability of functioning, removal and installation of the sensor-vyklyu-chatelya of fires of a backing
   Removal and installation of the mechanism of the drive of a speedometer
   Removal and installation of the transmission
   Capital repairs of RKPP, dismantling and assembly of knots and components
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and finishing of salon
+ Onboard electric equipment





Removal and installation of the mechanism of the drive of a speedometer

REMOVAL

 PERFORMANCE ORDER

1. In a motive compartment, in a back part of a case of RKPP find the speedometer drive device. Weaken (but do not turn off up to the end) a cap nut with a setup of fastening of a driving cable.

2. Turn out a fixing bolt and take a plate of fastening of the driving mechanism.
3. Having pulled for a cable, take outside assembly of the driving mechanism. Finally turn off a cap nut, disconnect a cable and remove the driving mechanism from the car.
4. Check a driving gear wheel of the mechanism for existence of the chopped-off or lost teeths. In case of need make replacement. Check a condition of a sealing ring. With defects the ring also should be replaced.

INSTALLATION

 PERFORMANCE ORDER

1. Track correctness of landing on the regular place of a sealing ring of assembly of the driving mechanism (before installation the ring should be oiled slightly).
2. Connect a driving cable to assembly, slightly having tightened a cap nut with a setup.
3. Put assembly on the regular place in the transmission, having tracked correctness of introduction in gearing of teeths of a gear wheel.
4. Establish a fixing plate, having tracked hit it in the leading grooves. Tighten a fixing bolt with the required effort.
5. Weaken a cap nut with a setup for the purpose of dumping of internal tension of the core of a cable, then again strongly tighten a nut.




Сливные насосы Помпы - Запчасти для стиральных машин