Skoda Felicia

1. Control of functioning of fires of a backing is exercised by means of the case of the transmission of the sensor switch of plunger type screwed from above in the basis. In case of violation of functioning of fires first of all check a condition of the corresponding safety lock.
2. For check of the sensor switch disconnect from it an electrical wiring (one or two sockets). By means of an ohmmeter or a lamp sampler make sure available conductivity between sensor switch plugs at the chosen reverse gear. In case of negative result of check and lack of visible defects of an electrical wiring of the corresponding contour it is necessary to replace actually the sensor switch.

1. Firmly cock the parking brake, then a front of the car and establish to a poddomkratta it on props.

2. Disconnect an electrical wiring from the sensor switch of fires of a backing - one or two sockets.

3. Prepare for collecting the spilled oil. Find a suitable stopper for an opening blockage under installation of the sensor switch.
4. Carefully wipe a case surface around the sensor switch. Turn out the sensor and remove it together with a sealing washer. Zakuporte an opening the prepared stopper.

1. Replace a sealing washer, then take a cap and screw the sensor switch on the regular place in a transmission case. Tighten the sensor with the required effort.
2. Restore initial connection of an electrical wiring, having tracked reliability of fastening of a plait in all intermediate clamps.
3. Lower the car on the earth and check the level of gearbox oil in the transmission. In case of need make the corresponding adjustment. Check serviceability of operation of fires of a backing.