Skoda Felicia

since 1994 release

Repair and operation of the car


Skoda Felicia
+ Cars of the Skoda Felicia brand
+ Maintenance instruction
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
- Power supply system
   + Power supply system of the carburetor engine of 1.3 l
   + System of the central injection (SPFI) of the petrol engine
   + System of the distributed injection (MPFI) of the petrol engine
   + Power supply system of the diesel engine
   - Systems of decrease in toxicity and production of the fulfilled gases
      System of catching of fuel evaporations - the general information and replacement of components
      System of ventilation of a case - the general information
      Removal and installation of the l-probe
      System of recirculation of the fulfilled gases (EGR) - the general information and replacement of components
      Removal and installation of a final collector
      System of release - the general information and replacement of components
      The catalytic converter - the general information and precautionary measures
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and finishing of salon
+ Onboard electric equipment


System of recirculation of the fulfilled gases (EGR) - the general information and replacement of components

REMOVAL

 PERFORMANCE ORDER

1. The oxygen sensor is screwed in a reception pipe of system of production of the fulfilled gases ahead of the catalytic converter.

2. Disconnect a negative wire from the battery.

3. Disunite the l-probe electrical wiring socket. The socket is fixed in the arm established on a thermostat casing. If two sockets are fixed in an arm, then will be necessary lower of them. Расстыковав I will corrode, release the plug from an arm.

As a part of a plait of an electrical wiring is built in in the sensor case, the reversing of the last requires a special cap key with a cutting head. Working under the car, turn out the l-probe from section of system of release. Try not to damage a sensitive working element of the sensor.

INSTALLATION

 PERFORMANCE ORDER

1. Slightly grease a carving part of the sensor with the anti-taking sealant which case it is not necessary to allow hits of sealant on a working element of the sensor.
2. Install the sensor in the casing and tighten it with the required effort. Restore initial connection of an electrical wiring. It is necessary to draw the attention of readers that on various cars the l-probes of various type which are not interchangeable can be installed.