Skoda Felicia

since 1994 release

Repair and operation of the car



Skoda Felicia
+ Cars of the Skoda Felicia brand
+ Maintenance instruction
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
- Power supply system
   + Power supply system of the carburetor engine of 1.3 l
   + System of the central injection (SPFI) of the petrol engine
   + System of the distributed injection (MPFI) of the petrol engine
   - Power supply system of the diesel engine
      General information and precautionary measures
      Removal and installation of assembly of the air cleaner and components of an inlet path
      Removal, installation and adjustment of a cable of an accelerator
      Removal and installation of the sensor of fuel consumption
      Removal and installation of the fuel tank
      Removal and TNVD installation
      Check and adjustment of the maximum turns of the engine and turns of idling
      Check of installation of turns of bystry idling
      Check and correction of installation of phases of injection of TNVD
      Removal and installation of nozzles
      Removal and installation of the electromagnetic locking valve
   + Systems of decrease in toxicity and production of the fulfilled gases
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and finishing of salon
+ Onboard electric equipment





Removal, installation and adjustment of a cable of an accelerator

REMOVAL

 PERFORMANCE ORDER

1. Remove the sections of finishing of the dashboard established under a steering column.
2. Slightly squeeze out a pedal of an accelerator and disconnect a tip of a driving cable from the plug on the top end of a pedal.
3. Having released the plug through passage, pass a cable through an opening in a partition of a motive compartment

4. In a motive compartment release a cable tip from the TNVD executive lever. Remove the rubber plug in which the tip is put.

5. Remove a lock cap of a cover of a cable and push the last through the rubber plug through passage. Release the plug from a basic arm of a cable.

6. Release a cable from the directing intermediate clamps and take it from a motive compartment.

INSTALLATION

 PERFORMANCE ORDER

Installation is made upside-down.

ADJUSTMENT

 PERFORMANCE ORDER

On TNVD record a cable cover in a basic arm, having filled a metal lock ring in one of specially provided flutes so that at full squeezing of the accelerator pedal the lever slightly nestled on the emphasis.