Skoda Felicia

since 1994 release

Repair and operation of the car



Skoda Felicia
+ Cars of the Skoda Felicia brand
+ Maintenance instruction
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
- Power supply system
   + Power supply system of the carburetor engine of 1.3 l
   + System of the central injection (SPFI) of the petrol engine
   - System of the distributed injection (MPFI) of the petrol engine
      General information and precautionary measures
      Removal and installation of assembly of the air cleaner
      The control unit temperature of the soaked-up air - the general information
      Removal, installation and adjustment of a cable of an accelerator
      Removal and installation of components of system of injection Simos 2P
      Removal and installation of components of system of injection Magneti-Marelli 1AV
      Removal and installation of assembly of the fuel pump and sensor of measurement of fuel consumption
      Removal and installation of the fuel tank
      Dumping of residual pressure in a power supply system
      Removal and installation of the inlet pipeline
      Check of serviceability of functioning and adjustment of system of injection
      Unleaded fuel - the general information and rules of use
   + Power supply system of the diesel engine
   + Systems of decrease in toxicity and production of the fulfilled gases
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and finishing of salon
+ Onboard electric equipment





Removal, installation and adjustment of a cable of an accelerator

REMOVAL

 PERFORMANCE ORDER

1. Uncover, installed on the throttle case (see the Section Removal and installation of assembly of the air cleaner).

2. On the case of a throttle disconnect the cable core from a plate of a spindle of a butterfly valve - the core should be delayed, and then to disconnect a cable tip.

3. Remove a lock cap from the external end of a cover of a cable.

4. Stretch a cable through the rubber plug through passage, having released it from a basic arm., then release the rubber plug through passage which then can be thrown off from a cover from a basic arm.

5. In interior of the car disconnect an internal tip of a cable from the plug on the top end of the accelerator pedal.

6. Release a cable from intermediate guides of clamps and pass through it through a partition of a motive compartment (try not to damage the rubber plug through passage).

INSTALLATION

 PERFORMANCE ORDER

1. Installation is made upside-down.

2. Record a cable cover in a basic arm on the throttle case for what latch a metal lock ring in one of cover grooves so that at completely squeezed out pedal the butterfly valve slightly nestled on a trailer emphasis.