Skoda Felicia

since 1994 release

Repair and operation of the car



Skoda Felicia
+ Cars of the Skoda Felicia brand
+ Maintenance instruction
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
- Power supply system
   + Power supply system of the carburetor engine of 1.3 l
   - System of the central injection (SPFI) of the petrol engine
      General information and precautionary measures
      Removal and installation of assembly of the air cleaner
      The vacuum switch of the control unit temperature of the soaked-up air
      Removal, installation and adjustment of a cable of an accelerator
      Removal and installation of components of the Bosch Mono-Motronic system
      Removal and installation of assembly of a gasoline pump and sensor of fuel consumption
      Removal and installation of the fuel tank
      Dumping of residual pressure in a power supply system
      Removal and installation of the inlet pipeline
      Check of functioning and adjustment of system of injection
      Unleaded fuel - the general information and rules of use
   + System of the distributed injection (MPFI) of the petrol engine
   + Power supply system of the diesel engine
   + Systems of decrease in toxicity and production of the fulfilled gases
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and finishing of salon
+ Onboard electric equipment





The vacuum switch of the control unit temperature of the soaked-up air

REMOVAL

 PERFORMANCE ORDER

1. Remove an air cleaner casing (see the Section Removal and installation of assembly of the air cleaner).
2. Disconnect from the vacuum switch the remained vacuum tube about (going to the vacuum capsule of a casing of the valve switch). Try a route of laying of a tube.
3. Having hooked the small screw-driver with a flat sting, remove a basic plate from the lower party of the vacuum switch. The plate can be put rather densely therefore act extremely carefully, trying not to damage nipple branch pipes.
4. Remove the vacuum switch from an air cleaner casing. Remove laying.

INSTALLATION

 PERFORMANCE ORDER

Installation is made upside-down. The damaged laying at assembly has to be replaced. Track density of landing of a basic plate on nipple branch pipes.