Skoda Felicia

since 1994 release

Repair and operation of the car

Skoda Felicia
+ Cars of the Skoda Felicia brand
+ Maintenance instruction
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system
- Engine electric equipment
   + Systems of a charge and start
   + System of ignition of petrol engines
   - System of preheat of diesel engines
      General information
      Removal and installation of components of a control system of preheat
      Check of a state, removal and installation of candles of an incandescence
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and finishing of salon
+ Onboard electric equipment

Removal and installation of components of a control system of preheat

REMOVAL

Control unit

PERFORMANCE ORDER

1. The control unit is located on an arm in a back part of a mudguard of an arch of the left wheel, a number of the relay of system of preheat.
2. Disconnect a negative wire from the battery.

3. At the corresponding complete set release fixing clamps and remove a plastic cover.

4. Disconnect an electrical wiring, then remove the control unit from a basic arm.

Relay

PERFORMANCE ORDER

Removal of the relay of system of preheat is made according to instructions, provided in paragraphs with 2 on 4.

INSTALLATION

PERFORMANCE ORDER

Installation is made upside-down. Track reliability of connection of an electrical wiring.