Skoda Felicia

since 1994 release

Repair and operation of the car



Skoda Felicia
+ Cars of the Skoda Felicia brand
+ Maintenance instruction
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
- Power supply system
   + Power supply system of the carburetor engine of 1.3 l
   - System of the central injection (SPFI) of the petrol engine
      General information and precautionary measures
      Removal and installation of assembly of the air cleaner
      The vacuum switch of the control unit temperature of the soaked-up air
      Removal, installation and adjustment of a cable of an accelerator
      Removal and installation of components of the Bosch Mono-Motronic system
      Removal and installation of assembly of a gasoline pump and sensor of fuel consumption
      Removal and installation of the fuel tank
      Dumping of residual pressure in a power supply system
      Removal and installation of the inlet pipeline
      Check of functioning and adjustment of system of injection
      Unleaded fuel - the general information and rules of use
   + System of the distributed injection (MPFI) of the petrol engine
   + Power supply system of the diesel engine
   + Systems of decrease in toxicity and production of the fulfilled gases
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and finishing of salon
+ Onboard electric equipment



Removal, installation and adjustment of a cable of an accelerator

REMOVAL

 PERFORMANCE ORDER

1. Remove an air cleaner casing (see the Section Removal and installation of assembly of the air cleaner).

2. On the case of a throttle disconnect the cable core from a plate of a spindle of a butterfly valve - the core should be delayed, and then to disconnect a tip.

3. Remove a cap from the external end of a cover of a cable, then release the rubber plug through passage which can be thrown off from a cover later from a basic arm.

4. In interior of the car release the connecting nipple of a cable from a clamp on the top end of a pedal of an accelerator.
5. Release a cable from intermediate guides of clamps and pass through it through a partition of a motive compartment (try not to damage the rubber plug through passage).

INSTALLATION

 PERFORMANCE ORDER

Installation is made upside-down.

ADJUSTMENT

 PERFORMANCE ORDER

Record a cable cover in a basic arm on the throttle case for what latch a metal lock ring in one of cover grooves so that at an emphasis of the lever of the drive of a butterfly valve in a stopper of provision of idling all weak point of a cable was chosen.