Skoda Felicia

since 1994 release

Repair and operation of the car



Skoda Felicia
+ Cars of the Skoda Felicia brand
+ Maintenance instruction
+ Routine maintenance
- Repair of the engine
   + Repair without extraction from the car of the petrol engine of 1.3 l
   - Repair without extraction from the car of the petrol engine of 1.6 l
      Description of the main knots and mechanisms
      Reduction of the piston of the first cylinder in the provision of the top dead point (TDP) of the end of a step of compression
      Check of compression pressure - an order of carrying out and interpretation of results
      Removal and installation of a belt of the GRM drive and its covers
      Removal, check of a state and installation of cogwheels and natyazhitel of a belt of the GRM drive
      Removal, installation and adjustment of effort of a tension of a belt of the drive of auxiliary units
      Removal and installation of a cover of a head of cylinders
      Replacement of an epiploon of the camshaft
      Replacement of epiploons of a bent shaft
      Removal and installation of a head of cylinders assembled with the inlet pipeline and a final collector
      Check of serviceability of functioning of hydraulic pushers
      Removal, check of a state and installation of a flywheel
      Check of a state and replacement of support of the power unit
      Removal and installation of the pallet of a case of the engine
      Removal and installation of the oil pump and maslozabornik
   + Repair without extraction from the car of the diesel engine
   + Dismantle of the power unit and capital repairs of the engine
+ Cooling systems, heating
+ Power supply system
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and finishing of salon
+ Onboard electric equipment



Check of a state and replacement of support of the power unit

Detailed information on placement and the device of support of the power unit is provided in Section 1 of Part D of the present Chapter.

CHECK

 PERFORMANCE ORDER

1. A car front also establish to Poddomkratta it on props.
2. Check rubber pillows of support for existence of cracks, signs of hardening, peelings of rubber from a metal basis and other mechanical damages. In case of detection of this sort of defects the faulty support is subject to replacement.
3. By means of a dynamometer key check correctness of effort of tightening of threaded connections of support.
4. Using the big screw-driver or mount as the lever, estimate degree of wear of support (whenever possible use the help of the assistant, having asked it to shake the power unit here and there). In case of identification of an excessive side play the worn-out support should be replaced, previously having checked reliability of tightening of its fixture.

REPLACEMENT

Right support

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. You will hang out the engine by means of the winch, or having propped up it a jack (between a head of a jack and the pallet of a case for distribution of loading it is necessary to lay wooden whetstone).

3. Turn out the top coupling bolt to an iotsoyedinita a support...

... trying to remember the adjusting provision of the removed components, take a rubber pillow from assembly.

4. Now the remained bolts can be turned out, and the support is removed from a wheel arch mudguard.
5. In case of need the lower part of a support can be separated from the engine block after preliminary removal of covers of a belt of the GRM drive (see the Section Removal and installation of a belt of the GRM drive and its covers).
6. Installation is made upside-down. Do not forget to replace fixing bolts and to slightly oil them before installation by lubricating. Tighten all fixture with the required effort.


Left support


See the Section Check of a State and Replacement of Rubber Pillows of Support of a Suspension Bracket of the Power Unit.

Back support


See the Section Check of a State and Replacement of Rubber Pillows of Support of a Suspension Bracket of the Power Unit.