Skoda Felicia

since 1994 release

Repair and operation of the car



Skoda Felicia
+ Cars of the Skoda Felicia brand
+ Maintenance instruction
- Routine maintenance
   Weekly checks
   + Routine maintenance of the car - petrol models
   - Routine maintenance of the car - diesel models
      Schedule of routine maintenance
      Regular service
      Replacement of motive oil and oil filter
      Removal of a sediment from the fuel filter
      Check of a condition of blocks and disks of forward brake mechanisms
      Check and adjustment of turns of idling
      Check of a condition of hoses, and identification of sources of leaks
      Check of a condition of protective covers of power shafts
      Suspension bracket and drive of steering
      Check of a condition of components of system of production of the fulfilled gases
      Check of a condition of cooling liquid
      Check of serviceability of functioning of coupling
      Greasing of locks and loops
      Check of composition of the fulfilled gases
      Adjustment of an optical axis of head headlights
      Check of serviceability of functioning of cleaners/washers of glasses/lenses of head headlights
      Trial runs
      Replacement of the filtering air cleaner element
      Replacement of the fuel filter
      Check of a condition of a belt of the GRM drive
      Check of a condition of a belt of the drive of auxiliary units
      Check of system of safety cushions
      Check of serviceability of functioning of systems of decrease in toxicity of the fulfilled engine gases
      Check of a condition of boots and drums of back brake mechanisms
      Check of serviceability of functioning of the parking brake
      Check of body panels on existence of traces of development of corrosion
      Check of level of gearbox oil
      Replacement of gearbox oil
      Replacement of a belt of the GRM drive
      Replacement of brake fluid
      Replacement of cooling liquid
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and finishing of salon
+ Onboard electric equipment



Check of level of gearbox oil

 PERFORMANCE ORDER

1. Tire out the car on a platform / a viewing hole, or and install to its poddomkratta it on props. Track that the car lifted above the ground settled down strictly in the horizontal plane. Check of level of gearbox oil is made before the first in the present day trip, or not less than 5 minutes later after an engine stop. Results of the car of measurement executed right after a stop cannot be considered reliable as a part of oil at the same time will be distributed on surfaces of internal components of the transmission.
2. Wipe RKPP case surface from above, around a speedometer drive arrangement.
3. Turn out a bolt, remove a fixing plate, then take assembly of the drive of a speedometer from a transmission case.
4. Check of level of gearbox oil is made by means of a driving gear wheel of a speedometer which in this case is used as the measuring probe. Dry wipe a gear wheel pure неворсящейся with rags, then against the stop fill driving assembly on the regular place in a transmission case. Again take assembly and determine oil level in a case by length of the moistened part of a gear wheel. The region of the moistened site of a gear wheel has to be located in 4 mm over the basis of the last. Insignificant excess of level of oil is allowed, however it should not fall below the stipulated point at all.
5. If level is insufficient, make the corresponding adjustment, filling in oil of the required grade through an opening under installation of assembly of the drive of a speedometer.
6. Excess of oil can be pumped out from a case through the same opening by means of the syringe or a rubber pear.
7. Having finished adjustment of level of oil, check a condition of a sealing ring of a driving gear wheel of a speedometer, replace a defective ring. Oil a new sealing ring pure gearbox and put driving assembly on the regular place in a transmission case. Enter a fixing plate into gearing with a groove to a gear wheel, then screw and tighten a fixing bolt with the required effort.

THROUGH EACH 60 000 KM OF THE RUN