Skoda Felicia

since 1994 release

Repair and operation of the car



Skoda Felicia
+ Cars of the Skoda Felicia brand
+ Maintenance instruction
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
- Brake system
   General information
   System design, description of separate knots and mechanisms
   Pumping of hydraulic system
   Replacement of hoses and tubes of a hydraulic path of the brake system
   Replacement of blocks of disk brake mechanisms of forward wheels
   Replacement of boots of drum brake mechanisms of back wheels
   Check of a state, removal and installation of disks of forward brake mechanisms
   Removal, check of a state and installation of reels of brake mechanisms of back wheels
   Removal, capital repairs and installation of supports of brake mechanisms of forward wheels
   Removal, capital repairs and installation of wheel cylinders of back brake mechanisms
   Removal, capital repairs and installation of the main brake cylinder (MBC)
   Removal and installation of a pedal of a foot brake
   Check of serviceability of functioning, removal and installation of the vacuum amplifier of brakes
   Removal, check of a state and installation of the control valve of the vacuum amplifier of brakes with a hose
   Adjustment of the parking brake
   Removal and installation of the lever of the parking brake
   Removal and installation of cables of the drive of the parking brake
   Check of serviceability of functioning, removal and installation of the valve regulator of pressure in hydraulic contours of brake mechanisms of back wheels
   Removal, installation and adjustment of the sensor switch of stoplights
   System of anti-blocking of brakes (ABS) - the general information
   Removal and installation of components of the ABS systems
   Removal and installation of the vacuum pump (diesel models)
   Check of a state and capital repairs of the vacuum pump (diesel models)
+ Suspension bracket and steering
+ Body and finishing of salon
+ Onboard electric equipment



Removal and installation of cables of the drive of the parking brake

REMOVAL

 PERFORMANCE ORDER

1. The driving cable of the parking brake consists of two separate main sections: right and left, the back wheels which are directly connecting brake mechanisms with a control lever the parking brake. Each of sections can be removed and replaced in an individual order.
2. For the purpose of ensuring access to a control lever the parking brake remove back section of the central console. On models without console remove a decorative cover of the lever.
3. Release kontryashchy and adjusting nuts and release the forward end of the cable which is subject to dismantle from a lever equalizer plate.
4. Prop up wedges forward wheels, then a back of the car and establish to a poddomkratta it on props. Remove the corresponding back wheel.
5. Remove a drum of the corresponding brake mechanism (see the Section Removal, check of a state and installation of reels of brake mechanisms of back wheels).
6. The screw-driver with a flat sting release the executive lever of the drive of the parking brake from a back part of a brake boot. Disconnect a cable from the lever and pass its tip through an opening in a brake board.
7. Moving along a cable, release it from intermediate clamps and bandages. Try to remember a route of laying of a cable. Replace the clamps damaged in the course of removal of a cable.

INSTALLATION

 PERFORMANCE ORDER

Installation is made upside-down. Track correctness of laying of a cable and reliability of its fastening in all provided clamps and bandages. Before installation of back section of the central console / a decorative cover of the lever make adjustment of the drive of the parking brake (see the Section Adjustment of the Parking Brake).