Skoda Felicia

since 1994 release

Repair and operation of the car



Skoda Felicia
+ Cars of the Skoda Felicia brand
+ Maintenance instruction
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
- Brake system
   General information
   System design, description of separate knots and mechanisms
   Pumping of hydraulic system
   Replacement of hoses and tubes of a hydraulic path of the brake system
   Replacement of blocks of disk brake mechanisms of forward wheels
   Replacement of boots of drum brake mechanisms of back wheels
   Check of a state, removal and installation of disks of forward brake mechanisms
   Removal, check of a state and installation of reels of brake mechanisms of back wheels
   Removal, capital repairs and installation of supports of brake mechanisms of forward wheels
   Removal, capital repairs and installation of wheel cylinders of back brake mechanisms
   Removal, capital repairs and installation of the main brake cylinder (MBC)
   Removal and installation of a pedal of a foot brake
   Check of serviceability of functioning, removal and installation of the vacuum amplifier of brakes
   Removal, check of a state and installation of the control valve of the vacuum amplifier of brakes with a hose
   Adjustment of the parking brake
   Removal and installation of the lever of the parking brake
   Removal and installation of cables of the drive of the parking brake
   Check of serviceability of functioning, removal and installation of the valve regulator of pressure in hydraulic contours of brake mechanisms of back wheels
   Removal, installation and adjustment of the sensor switch of stoplights
   System of anti-blocking of brakes (ABS) - the general information
   Removal and installation of components of the ABS systems
   Removal and installation of the vacuum pump (diesel models)
   Check of a state and capital repairs of the vacuum pump (diesel models)
+ Suspension bracket and steering
+ Body and finishing of salon
+ Onboard electric equipment



General information

At service of any of components of the brake system it is necessary to work extremely accurately, methodically performing all procedures described in the present manual as appropriate. During the works with components of a hydraulic path special attention needs to be paid to respect for purity. In the absence of confidence in correctness of assessment of a condition of components, without thinking you make their replacement (in a set for this axis of the car). As replaceable use only company details of production of the Skoda company, or not of a lower quality them.


All models are equipped with the 2-circuit brake system of hydraulic type with vacuum strengthening. The Main Brake Cylinder (MBC) has a dual design. Contours of hydraulic system function independently, i.e. in case of refusal one of them, the second continues to provide adequate braking of the car with two wheels. In normal conditions both brake contours function in unison. The system of anti-blocking of brakes (ABS) is included in a basic equipment of some models, on others can be established in addition (for more details see the Section Removal and installation of components of the ABS systems).

Brake mechanisms of forward wheels on all models have a disk design. Back wheels are equipped with drum brake mechanisms. Supports of disk brake mechanisms have a one-piston design with the floating bracket providing uniformity of distribution of effort between two to brake shoes. The forward and back boots put in action by the 2-piston wheel cylinder are placed in drums of brake mechanisms of back wheels. The special adjusting mechanism automatically compensates wear of frictional slips due to updating of the provision of boots.

On not equipped ABS models the hydraulic contour of back brake mechanisms switched on pressure valve regulator. The valve can react to change both pressure in a contour, and extent of loading of the car, and in the first case two valves (on one on everyone their wheels) rolled directly in GTTs, and in the second - one, fixed on a body of the car and connected to the back bridge a spring are used. Existence of the valve regulator(s) allows system to correct in due time pressure in hydraulic contours of brake mechanisms of back wheels, preventing thereby premature blocking of the last at sharp braking.

The parking brake has the independent mechanical drive and influences back wheels of the car.